Repeater cables for Motorola GM CDM series radio, GM300, CDM1250, 16 pin

Description: Repeater controller is NOT included This listing is for the two cables shown in first picture This listing includes REPEATER CONTROLLER SHOWN IN 2ND PICTURE IS NOT INCLUDED! ONLY SHOWN FOR HOW TO CONNECT TO YOUR ID-IO-MATIC CONTROLLERThese cables may be use with other controllers, see below for wire colors and functionsUsing a repeater controller with these two 16 pin rear accessory connectors (one for TX radio, one for RX radio) make an instant repeater from any two compatible Motorola radios (Any Motorola radios with 16 or 20 pin rear accy connector, programmed for pin-8 COR active low (or high changed in programming). For CDM radios, use center 16 pins. Wire length, about 12 inchesCompatible with GM300, M10, M120, Maxtrac (WITH 16 pin rear connector), CDM750, CDM1250, CDM1550, M1225, CM200, SM50, SM120 and any Motorola radios with 16 or 20 pin rear accy connectors, programmed for pin-8 COR active low (or high changed in programming) (Not compatible with GTX)Wires shown with ends stripped. They will be shipped with full insulation. YOU need to strip ends of wires to your needsMotorola radios using 16 or 20 pin rear accy connector pins TX radio pins: Pin 2 Mic Hi (audio in) (WHITE to pin 11 IDOM4) Pin 3 PTT active low (GREEN to pin 3 IDOM4) Pin 7 Ground (BLACK to pin 1 or 12 IDOM4)RX radio pins: Pin 7 Ground (BLACK to pin 1 or 12 IDOM4) Pin 8 COR (active low is default for IDOM4) (BLUE to pin 7 IDOM4) Pin 11 discriminator audio out (YELLOW to pin 8 IDOM4) Pin 13 +12 vdc (this is where IDOM4 gets its power) (RED to pin 2 IDOM4)Need a repeater controller? See our eBay store Why buy from Radiodan W7RF? Active on-the-air every day, see our QRZ page We ARE the manufacturer! 100% QC testing! IN-STOCK for Immediate shipment. We get it out the same or next day depending on when you order.

Price: 29.95 USD

Location: Fort Collins, Colorado

End Time: 2024-02-24T01:04:38.000Z

Shipping Cost: 0 USD