Description: Mini Ugly Stick RC airplane kit. Under 10 oz total flying weight! 23" wingspan. Fits a wide range of RC airplane brushless motors, as well as common drone electronics. This is the perfect park and yard flyer! The airframe is 3D printed. It's much tougher and a little lighter than balsa. These will take a beating! The covering is a vinyl-type adhesive covering that comes pre-cut. It's like putting on a stickers - very simple and no heat required! Check it out on 3D RC Hobby! This high-wing model is a great trainer for beginners who are just getting into the hobby, but also great for aerobatics. With stable flying at high or low speeds, this is a great choice for flyers of all skill levels. The Ugly Stick ARF (Almost Ready to Fly) Kit comes with the complete airframe, pre-cut covering & decals, control surface hinges, along with pushrods & servo horns, and instructions. The Ugly Stick can be ready to fly in less than one hour. All you need is a small amount of glue (CA or Super Glue), a battery and your choice of electronics (not included). Airplane Specifications: Material: 3D printed (PLA MAX) Control Type: Throttle, Ailerons, Elevator and Rudder. Wingspan: 23 inches Length: 16 inches Flying Weight: Approx. 10 oz (varies slightly with motor and battery size) Recommended electronics (NOT included): Servos: 3.7 gram micro (x4) Motor Size: 1806-2200 800+ kv ESC: 12 amp with BEC Propeller: 5-6 inch Battery: 2s lipo 7.4v 200-400 mAh with XT30 connector Radio / Receiver: 4-channel radio / receiver *The photos show the plane with motor and propeller. These are NOT included*
Price: 90 USD
Location: Fruitland, Utah
End Time: 2024-11-21T05:55:46.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Brand: 3D RC HOBBY
MPN: N/A
