grey skull castle mini dice roller tower with tray/castle/skull/DnD/Tabletop RPG

Description: skull castle mini dice roller tower with tray- dice roller tower with tray- DnD/Pathfinder/Tabletop RPG please note these mini dice tower are for D20 20mm dice and under and will not work with dice over 20mm(All mini dice towers are tested and work with d20 20mm dice thanks) PLEASE READ BEFORE ORDERINGTHIS MINI DICE TOWER IS NOT FOR DICE OVER 20 MM AS STATED ABOVE DO NOT ORDER THIS ITEM IF YOUR D20 DICE ARE BIGGER THAN 20MM AS THEY ONLY WORK WITH D20 20MM AND UNDER This item is made from grey PLA and is printed ready to dispatch/The dice tray slides on and off the the bottom of the dice tower - dice roller tower with tray- DnD/Pathfinder/Tabletop RPG Approximate size: full tower L 70mm x W 71mm x H114mmpiece 1 castle top dice tower (70 mm long x 70 mm wide x 83mm tall)piece 2 castle top dice tower (64 mm long x 67 mm wide x 31mm tall) + 3 pegspiece 3 removable dice tray (117mm long x 81mm wide x 25mm tall) this dice tower fits together very easily just put a bit of glue on the pegs in the holes and fit the two parts togetherdice not included for scale only This listing is for an one dice tower and tray.Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design. However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish. Create the ultimate game table with This cool tower.

Price: 11.99 GBP

Location: Holyhead

End Time: 2024-11-25T23:20:49.000Z

Shipping Cost: 25.14 GBP